Navico Fuel Flow Sensor za benzinske motore
Part Number: 000-11517-001
- Fuel Flow Sensor
- For gasoline engines
- In-line sensor for 3/8" (9.5 mm)
- Inside Diameter fuel line.
- Comes with 10ft cable and T-connector.
......................................................................................................................................................
Fuel Flow Sensor Gasoline only. One required per engine. Up to 3 engines supported. To get data on Fuel Remaining in the vessel tanks requires a 000-11522-001 Fuel Data Manager.
Outputs:
- Fuel Flow
- Tank Fuel Used
- Trip Fuel Used
- Seasonal Fuel Used
| Cable Length |
10 Ft |
| Fuel Line Diameter |
3/8" (9.5 mm) Inside Diameter |
| Flow Rate Measured |
Optimized for 0.6-45 Gal/hr but can measure outside these values |
| Added Back Pressure to the fuel system |
0.5 PSI at 20 Gal/hr; 1 PSI at 40 Gal/hr |
| Installation Location |
Above the max level of the fuel tank, in-line after the fuel filter and any Y's or T's in the line |
| Package contents |
Fuel Flow Sensor, N2K T and 2 (two) 1" hose clamps |
| Fuel Type |
Gasoline only. The Fuel Flow Sensor does not operate diesel engine fuel systems. |
| Hole required to route through a bulkhead |
22mm (7/8") |
| Multiple Fuel Flow sensors possible |
Yes |
......................................................................................................................................................
Specifications:
| Cable Length |
10 Ft |
| Fuel Line Diameter |
3/8" (9.5 mm) Inside Diameter |
| Flow Rate Measured |
Optimized for 0.6-45 Gal/hr but can measure outside these values |
| Added Back Pressure to the fuel system |
0.5 PSI at 20 Gal/hr; 1 PSI at 40 Gal/hr |
| Installation Location |
Above the max level of the fuel tank, in-line after the fuel filter and any Y's or T's in the line |
| Package |
The Fuel Flow Sensor, N2K T and 2 (two) 1" hose clamps |
| Fuel Type |
Gasoline only. The Fuel Flow Sensor does not operate diesel engine fuel systems, or on any fuel system with a return line or sump. |
| Hole required to route through a bulkhead |
22mm (7/8") |
| Multiple Fuel Flow Sensors possible |
Yes |
